您好,欢迎访问河北润豪泵业有限公司!
10年专注水泵产品研发制造 水泵产品设计\制作\安装一条龙服务
全国咨询热线:15010006020
当前位置: 首页 > 新闻中心 > 公司新闻

潜水抽沙泵的使用方法

作者:小编 时间:2021-05-30 22:33:41 点击:

潜水抽沙泵在使用潜水抽沙泵期间,每种情况的战场条件都不是一般的,其运输隔离程度,分散程度,是否包含大颗粒或其他杂质。 一次使用相同的地址泵送时,一定不能太深,否则很容易导致砂层突然塌陷并埋没潜水泵。

During the use of submersible sand pump, the battlefield conditions of each case are not general, such as the transportation isolation degree, dispersion degree, whether it contains large particles or other impurities. When pumping with the same address, it must not be too deep, otherwise it is easy to cause the sand layer to collapse suddenly and bury the submersible pump.

  方法:泵深3-5米,移动浮体,然后继续泵; 协助潜水抽沙泵的冲洗安装,以减少沙坑的面积。 在使用期间,当泵送相同的地址一次时,潜水抽沙泵不能太深。 否则,很容易导致砂层突然坍塌并埋没潜水抽沙泵。 沙子中含有一定比例的卵石。

Methods: the depth of the pump was 3-5M, the floating body was moved, and then the pump was continued; Assist in the flushing and installation of submersible sand pump to reduce the area of sand pit. During use, when pumping the same address once, the submersible sand pump should not be too deep. Otherwise, it is easy to cause the sand layer collapse suddenly and bury the submersible sand pump. The sand contains a certain proportion of pebbles.

  这些卵石很容易吸附在砂泵的滤网上,并充当水上的砂泵。 如果没有立即清理,则砂泵的供水量将大大下降,甚至会造成障碍。 创建一个水滴,然后立即关闭以除去过滤器上的石头。 使用完毕后,将潜水抽沙泵收起后,要确保设备内部清洁,清除设备内部磨损的杂质,避免积累过多而形成障碍物。

These pebbles are easily adsorbed on the filter screen of sand pump and act as sand pump on water. If it is not cleaned immediately, the water supply of sand pump will be greatly reduced, and even cause obstacles. Create a water drop and immediately close to remove the stone from the filter. After use, after the submersible sand pump is put away, it is necessary to ensure the internal cleanliness of the equipment, remove the worn impurities inside the equipment, and avoid the accumulation of excessive obstacles.

潜水抽沙泵的使用方法(图1)